 | | Re: A couple of gear questions
|
|
(...) For most applications it dosen't really pose a noticeable problem. However this inconsistancey is due to the internal structure and the way in which friction is achived. (URL) the only problem I have with it is that the clutch slips way too (...) (16 years ago, 16-Apr-09, to lugnet.technic)
|
| |
| | Re: A couple of gear questions
|
|
(...) I think it's a non-issue for the most part. The torque isn't really "over a range" - it's different for different clutch gears, but for any *single* clutch gear it's pretty constant. After all, if it has a point at which it starts slipping, it (...) (16 years ago, 16-Apr-09, to lugnet.technic)
|
| |
| | Re: A couple of gear questions
|
|
(...) (URL) you can see the writing, and why the torque over a range. Is a non constant-clutching like this good or bad? What do people think? (16 years ago, 16-Apr-09, to lugnet.technic)
|
| |
| | Shock absorbers stiffness
|
|
An approximate measurement of stiffness of different shock absorbers at full compression. (3 URLs) Philo> (16 years ago, 13-Apr-09, to lugnet.technic, FTX)
|
| |
| | Re: Help needed on gear spacing, and another question
|
|
(...) No! They're properly aligned. ;) They just look like that, because the way the worm termination is done. However the screw works continuous and smoothly. (16 years ago, 8-Apr-09, to lugnet.technic, FTX)
|
