|
|
 | | Re: New Crane...
|
| (...) It worked pretty well for me on this one: (URL) all of these: (URL) have had no problems with the two parts coming apart....If you can tell by this pic, the red and white one is holding up a 8421 almost 8 feet away from the center of (...) (17 years ago, 22-Feb-08, to lugnet.technic)
| | | | | Re: New Crane...
|
| (...) Thanks, read about it (URL) here>. ROSCO (17 years ago, 21-Feb-08, to lugnet.technic, FTX)
| | | | | Re: New Crane...
|
| (...) Great crane Rosco, shame their's no accompanying text. Steve (17 years ago, 21-Feb-08, to lugnet.technic, FTX)
| | | | | Re: New Crane...
|
| (...) Yes, that is correct. (...) See also (URL) technique> - this allowed me to lift the whole crane base up by the superstructure. ROSCO (17 years ago, 21-Feb-08, to lugnet.technic, FTX)
| | | | | Re: New Crane...
|
| (...) Mine has that. (17 years ago, 21-Feb-08, to lugnet.technic)
| | | | | Re: Technicopedia Update
|
| I have to say that's an absolutely amazing site! Fascinating stuff, I have it bookmarked and I'm looking forward to the rest of your updates! :-) (17 years ago, 21-Feb-08, to lugnet.technic)
| | | | | Re: New Crane...
|
| (...) This is correct. Real cranes have roller bearings that are pinned in place that bear the weight and force of the superstructure where it is connected to the base. (...) I am going to use a threaded axle through the center to hold the plates (...) (17 years ago, 21-Feb-08, to lugnet.technic)
| | | | | What should happen with the lugnet.robotics.nxt sidebar?
|
| Hello, LUGNET readers. In case you don't know, I'm the lugnet.robotics.nxt curator. I used to update the NXT section sidebar with [in]frequent regularity, but during the last couple months I've not done anything to it. I get busy and/or don't take (...) (17 years ago, 21-Feb-08, to lugnet.robotics.nxt, lugnet.technic, lugnet.general, lugnet.admin.curators)
| | | | | Re: Linear Actuator
|
| (...) Obviously with *my* interests, I hope that the linear actuator is not the end of pneumatics. There are still a lot of ideas I've not had a chance to try, but more part type options are great! Kevin (www.kclague.net) (17 years ago, 21-Feb-08, to lugnet.technic)
| | | | | Linear Actuator
|
| The more I think about the new linear actuator the more applications I think up for it, but I was just wondering is it actually going to be significantly cheaper to make than the pneumatic system? I know you won't need a pump, valve block or pipes, (...) (17 years ago, 21-Feb-08, to lugnet.technic)
|
|
