To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 16290 (-10)
  Re: New Crane...
 
(...) Thanks, read about it (URL) here>. ROSCO (17 years ago, 21-Feb-08, to lugnet.technic, FTX)
 
  Re: New Crane...
 
(...) Great crane Rosco, shame their's no accompanying text. Steve (17 years ago, 21-Feb-08, to lugnet.technic, FTX)
 
  Re: New Crane...
 
(...) Yes, that is correct. (...) See also (URL) technique> - this allowed me to lift the whole crane base up by the superstructure. ROSCO (17 years ago, 21-Feb-08, to lugnet.technic, FTX)
 
  Re: New Crane...
 
(...) Mine has that. (17 years ago, 21-Feb-08, to lugnet.technic)
 
  Re: Technicopedia Update
 
I have to say that's an absolutely amazing site! Fascinating stuff, I have it bookmarked and I'm looking forward to the rest of your updates! :-) (17 years ago, 21-Feb-08, to lugnet.technic)
 
  Re: New Crane...
 
(...) This is correct. Real cranes have roller bearings that are pinned in place that bear the weight and force of the superstructure where it is connected to the base. (...) I am going to use a threaded axle through the center to hold the plates (...) (17 years ago, 21-Feb-08, to lugnet.technic)
 
  What should happen with the lugnet.robotics.nxt sidebar?
 
Hello, LUGNET readers. In case you don't know, I'm the lugnet.robotics.nxt curator. I used to update the NXT section sidebar with [in]frequent regularity, but during the last couple months I've not done anything to it. I get busy and/or don't take (...) (17 years ago, 21-Feb-08, to lugnet.robotics.nxt, lugnet.technic, lugnet.general, lugnet.admin.curators)  
 
  Re: Linear Actuator
 
(...) Obviously with *my* interests, I hope that the linear actuator is not the end of pneumatics. There are still a lot of ideas I've not had a chance to try, but more part type options are great! Kevin (www.kclague.net) (17 years ago, 21-Feb-08, to lugnet.technic)
 
  Linear Actuator
 
The more I think about the new linear actuator the more applications I think up for it, but I was just wondering is it actually going to be significantly cheaper to make than the pneumatic system? I know you won't need a pump, valve block or pipes, (...) (17 years ago, 21-Feb-08, to lugnet.technic)
 
  Re: New Panel Fairings?
 
(...) Gordons's right, I'm currently pro the new fairings. I like my parts to be made up of recognisable geometric shapes and have lines of symmetry :-). (17 years ago, 21-Feb-08, to lugnet.technic)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR