Subject:
|
Re: best way to attach stud to axle?
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Tue, 4 Sep 2007 19:24:38 GMT
|
Viewed:
|
8760 times
|
| |
|
|
In lugnet.technic, Daniel Rojas wrote:
> >
> > What about two 2x2 round plates with a 1x1 round plate in the middle of the 4
> > studs?
>
> i tried that, it breaks off way too easily... especially when it gets pressure
> from the side.
If you have enough lateral pressure to shift a 1x1 plate from between 4 studs,
you almost certainly have enough lateral pressure to shift anything connected to
the stud.
How much space have you got depth wise? How about a 1x1 round brick onto a 2x2
round brick and then use a (cut) length of flex tube down the middle of the 1x1
round and into the 2x2 round to reinforce the joint?
|
|
Message has 1 Reply:
 | | Re: best way to attach stud to axle?
|
| (...) well, the round plate between the studs probably won't come off, but anything attached to it will. i want to attach probably some sqare 1x1 plates or one 1x1 brick. the flex idea is not bad at all, but won't work for all bricks. all this is (...) (17 years ago, 5-Sep-07, to lugnet.technic)
|
Message is in Reply To:
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
