Subject:
|
Re: best way to attach stud to axle?
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Tue, 4 Sep 2007 18:35:19 GMT
|
Viewed:
|
8277 times
|
| |
|
|
In lugnet.technic, Daniel Rojas wrote:
> hey!
>
> i want to attach a normal lego stud (or its bottom counterpart, doesn't matter)
> to a rotating technic axle, so that a normal 1x1 plate, tile or brick can rotate
> with it.
> - it HAS to be only 1 stud at the end, something with 2x2 may be inbetween if it
> makes mounting easier
> - it should be held as firmly as possible. it should neither slip if the brick
> encounters resitance, nor break off all too easily.
>
> i know it's a lot to ask, but maybe there's a way?
>
> the best way i've found is connecting the axle to a 1x2 brick with axlehole.
> this is coupled to a 1x2 brick with the round hole on top and bottom so that
> both hole centers align. then i can insert a stud into the round hole.
> it works, but it's pretty bulky...
>
> some stuff that doesn't work:
> the stud on the 3 long axis with the stud, it doesn't attach firmly enough.
> a 1x1 cone ( http://peeron.com/inv/parts/4589 ). it holds a technic axle on the
> bottom, but it's just too weak.
>
> thanks for any ideas!
What about two 2x2 round plates with a 1x1 round plate in the middle of the 4
studs?
|
|
Message has 1 Reply:
Message is in Reply To:
 | | best way to attach stud to axle?
|
| hey! i want to attach a normal lego stud (or its bottom counterpart, doesn't matter) to a rotating technic axle, so that a normal 1x1 plate, tile or brick can rotate with it. - it HAS to be only 1 stud at the end, something with 2x2 may be inbetween (...) (17 years ago, 4-Sep-07, to lugnet.technic)
|
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
