 | | Re: Need to figure out how to get this motor unit attached.
|
|
(...) One-way can also be done with an gear on the pivot of an arm meshing with an idler gear on the end that swings between two close gears. You wouldn't have to go through any 90 deg twists then. :P (...) I could be wrong, but I thought that the (...) (18 years ago, 19-Apr-06, to lugnet.technic)
|
| |
| | Re: Need to figure out how to get this motor unit attached.
|
|
"Chris Orchard" <chris_orchard@+Remo...es.com.au> wrote in message news:Ixy4C6.CyI@lugnet.com... (...) The worm gear pics that I loaded into the folder recently are for a one-way worm gear drive. This basically is so I can set the hopper on and (...) (18 years ago, 19-Apr-06, to lugnet.technic)
|
| |
| | Re: Need to figure out how to get this motor unit attached.
|
|
(...) Hi Geoffrey, I think the easiest way to turn gearing through use of the worm gear, however as others will point out a worm gear is not very efficient gearing down mechanism, also if this is run for several hours at a time, the meshed gears (...) (18 years ago, 19-Apr-06, to lugnet.technic)
|
| |
| | Mindstorms.NET Request for Comments
|
|
I've been working with José David Parra on the next version of his (URL) RCX.NET> project, because 1.) the NXT system is coming out, and 2.) RCX.NET is basically a .NET wrapper of Spirit.ocx, which means it's not so nice to program with. Another (...) (18 years ago, 17-Apr-06, to lugnet.robotics, lugnet.technic, lugnet.announce, lugnet.robotics.rcx, lugnet.robotics.scout, FTX)
|
| |
| | Re: Request for info on the Control Lab Interface.
|
|
(...) Another question: Does this device work with serial port to USB adapters? I'd like to make this code as robust as possible, so this would be nice to know. If so, then I'd need to know if those adapters map themselves to the equivalent of COM1, (...) (18 years ago, 14-Apr-06, to lugnet.robotics, lugnet.technic, FTX)
|
