 | | Re: 9V batery box (6 AA) - pressed too much
|
|
"Mark Bellis" <mark.bellis@tiscali.co.uk> wrote in message news:InzIxI.192w@lugnet.com... (...) <snip> (...) I think that is indeed what is hapening. If you press down (say on the right side) the motor runs, but if you keep pressing harder, watch (...) (19 years ago, 10-Oct-05, to lugnet.technic)
|
| |
| | Schematic for inchworm
|
|
Hi, I've gotten into drawing schmeatics lately. I just finished a hairy one for a hexapod with three leg grouls (hex464). I decided to try something simpler so I drew up a schematic for my inchworm. I know Bob Kojima wanted to see this a few years (...) (19 years ago, 7-Oct-05, to lugnet.technic)
|
| |
| | Re: 9V batery box (6 AA) - pressed too much
|
|
(...) Steve, your right, normally its not required to hold down the switch beyond what the original spec is. BUT in this case I would have thought a beam right on top would suffice. I was shocked to see the effect I noticed, and wanted to ask people (...) (19 years ago, 7-Oct-05, to lugnet.technic)
|
| |
| | Re: 9V batery box (6 AA) - pressed too much
|
|
(...) I've never found in necessary to do more than let them hold themselves. If I'm worried about the switch being unpressed, I'll build something over the top, to make sure they won't get hit elsewhere. Steve (19 years ago, 7-Oct-05, to lugnet.technic)
|
| |
| | Re: 9V batery box (6 AA) - pressed too much
|
|
(...) I wouldn't call it elegant, but it works. I used a pair of those egg shaped cams set at right angles on the same shaft, one over each battery box button. With both cams at 45 degs, neither button is pressed. With + and - 45 deg drive to the (...) (19 years ago, 7-Oct-05, to lugnet.technic)
|
