 | | Re: 9V batery box (6 AA) - pressed too much
|
|
(...) Hi Chris, If you just leave the motor on without pressing the red button does it also stop? The battery boxes have a built in current limiter that will stop current flow if you are drawing too much power. Could that be the problem? Kev (19 years ago, 6-Oct-05, to lugnet.technic)
|
| |
| | Re: Hex565 - one leg at at time pneumatic hexapod
|
|
(...) <snip> (...) I find it pleasing to watch also. It is very decisive about its stepping. When legs are moving individually, they do so realtively quickly, and then they all move at once, you see a definite lurch in body location. There is (...) (19 years ago, 6-Oct-05, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: Technic question: how to connect 2 technic beams
|
|
(...) The offset cam will be too tight. I believe Zoltan Schuster and Dennis Bossman have the solution. Turn one beam upsidedown and leave the other right side up This will make the verticle distance between the holes exactly the 45 degree diagonal (...) (19 years ago, 6-Oct-05, to lugnet.technic, FTX)
|
| |
| | 9V batery box (6 AA) - pressed too much
|
|
At the last robot contest, I discovered that if I press down on either side of the battery box red switch, the power stops. It is hard to put into words. If you hook up a motor to this battery box: (URL) press the red button, the motor spins. if (...) (19 years ago, 6-Oct-05, to lugnet.technic)
|
| |
| | Re: Technic question: how to connect 2 technic beams
|
|
(...) Thanks for your suggestions. I have a number of restrictions for this specific design... but have been wondering in general the best way. (So far I think Mark has the best suggestion using an offset cam). For this specific project I am (...) (19 years ago, 6-Oct-05, to lugnet.technic, FTX)
|
