Subject:
|
Re: Help please: I'm trying to get two outputs from one shaft
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Thu, 29 Sep 2005 15:42:18 GMT
|
Viewed:
|
4267 times
|
| |
|
|
In lugnet.technic, Tony Hafner wrote:
> Followup... this works beautifully. I was a little worried at a few stages of
> construction when the 1x4 brick sometimes would rotate until it wasn't engaging
> either gear and then sit there with the 8t gears spinning freely- but in the
> full assembly it's quite reliable.
> (snip)
> Tony Hafner
> www.hafhead.com
Hi Tony,
I'm glad I could help...
I've added three more simple mechanisms to the webpage (actualy two pages now):
http://wegmuller.org/v-web/gallery/OneInTwoOut?page=1
http://wegmuller.org/v-web/gallery/OneInTwoOut?page=2
They are:
- The walking worm gear one into two. This turned out to be very compact but not
as reliable as the spur gear one because some times the worm jams into a gear
when trying to engage it...
- A very small ratchet, using an eight-tooth gear and a rubber band, so it works
in any position.
- A stepless ratchet mechanism using a pair of wheels with rubber tires.
Greetings,
David Wegmuller
|
|
Message is in Reply To:
7 Messages in This Thread:
  
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
