| | Re: Help please: I'm trying to get two outputs from one shaft
|
|
(...) That looks a very nice simple solution to the problem, the simple solutions are usually the best! I will certainly be using it to give more function from the auxiliary output of the RC car unit. Tim (19 years ago, 28-Sep-05, to lugnet.technic)
|
|
| | Re: Help please: I'm trying to get two outputs from one shaft
|
|
(...) Followup... this works beautifully. I was a little worried at a few stages of construction when the 1x4 brick sometimes would rotate until it wasn't engaging either gear and then sit there with the 8t gears spinning freely- but in the full (...) (19 years ago, 28-Sep-05, to lugnet.technic)
|
|
| | Re: Help please: I'm trying to get two outputs from one shaft
|
|
(...) I will have to dig it out - but somewhere I have a fairly simple LDraw file showing that sliding worm gear device. I also made an interesting variation on this using Lego clutch gears which allowed 2 motors to give 2 outputs each, plus an (...) (19 years ago, 28-Sep-05, to lugnet.technic)
|
|
| | Re: New technique: three position piston control
|
|
(...) Mark, Did I miss your answer on this? Kev (...) (19 years ago, 28-Sep-05, to lugnet.technic, lugnet.robotics)
|
|
| | Re: Help please: I'm trying to get two outputs from one shaft
|
|
(...) This is great stuff, and will probably work for my application. It's mechanically much simpler than a differential with rachets. Thanks!! (...) I think I can picture how that works: You have a 4-stud-long box with a shaft running lengthwise (...) (19 years ago, 27-Sep-05, to lugnet.technic)
|