To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 14333
    Re: 8421 first impressions —Vineet Honkan
   Yes. When I built the crane, I had the same problem. This can be fixed however. All you have to do is attach the extra tubes. (19 years ago, 1-Jul-05, to lugnet.technic)
   
        Re: 8421 first impressions —Gyl Midroni
   (...) Hi Vineet. In what way did you atached the extra tubes (there were a few cm of back and blue tubing left over after I cut the size I needed - I assume you are referring to those). Thanks, Gyl (19 years ago, 1-Jul-05, to lugnet.technic)
   
        Re: 8421 first impressions —Thomas D. Fulk, Jr.
   (...) I will make an assumption (not always a good idea) and say the 2 unused cylinder retract ports should be hooked together with 2 legs of a Tee, then the third leg of the Tee attaced to the unused port on the pneumatic switch. Every other (...) (19 years ago, 2-Jul-05, to lugnet.technic)
   
        Re: 8421 first impressions —Gyl Midroni
   (...) Thanks, I did do that and it works so so, but not great (I stil have to very carefully partially open the switch so it leaks slowly) but certainly better than before. What's wierd is that there is actually an extra tee in the set, although not (...) (19 years ago, 2-Jul-05, to lugnet.technic)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR