 | | Re: Concentric drive (was Re: genuinemodels.com down?)
|
|
(...) So what was the solution? Jude (19 years ago, 29-May-05, to lugnet.technic)
|
| |
| | Re: Concentric drive (was Re: genuinemodels.com down?)
|
|
(...) Bad form to reply to myself twice in the same thread, but I've figured out a solution. Wish it were a bit smaller, but that's life with limited gear geometries... --Bram (19 years ago, 29-May-05, to lugnet.technic)
|
| |
| | Re: genuinemodels.com down?
|
|
(...) Yes, it looks like the Telepresence site is down. (...) I think most 3 shaft implementations involve a differential (URL) passing through the centre of a large technic turntable (URL) and an axle through the centre of the diff (that is how Jen (...) (19 years ago, 29-May-05, to lugnet.technic)
|
| |
| | Concentric drive (was Re: genuinemodels.com down?)
|
|
(...) Specifically, I'm trying to come up with a way to have two pieces rotating in opposite direction along a stationary shaft which extends all the way through the mechanism. The drive for the rotating components should be on the stationary (...) (19 years ago, 29-May-05, to lugnet.technic)
|
| |
| | genuinemodels.com down?
|
|
Is Jennifer's website down? I'm looking for the page describing getting concentric shafts through a turntable. Really, I'm looking for any way to accomplish concentric shafts (3 would be great) in as small a space as possible. Any ideas? --Bram (19 years ago, 28-May-05, to lugnet.technic)
|
