Subject:
|
Re: Instant Mini Air Compressor using RC Buggy Motor
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Sat, 26 Jun 2004 05:27:21 GMT
|
Viewed:
|
2616 times
|
| |
|
|
In lugnet.technic, Ross Crawford wrote:
| |
In lugnet.technic, Chio Siong Soh wrote:
|
| |
| |
Thanks, but actually the design suggested of itself. Normally, one would use
the outer motor output shaft. But I was struck by the exact geometry using
the inner motor output shaft and the small pump. Is it a fortuitous
coincidence or is it an intended design by TLC?
And yes, it does run warm at the high rev, so it may merit a
Surgeon-General’s WARNING: Prolonged usage may be detrimental to the
health of your pump.
|
Or someone design a LEGO cooling system ;)
ROSCO
|
Air cooled, of course. Right? :-)
Hi CSSOH. Simplicity and performance. Nice work!
BTW, Rosco, I look forward to seeing more of your crane. It is very impressive.
Only 2 days ago some one upset a crane at work by failing to put the outriggers
down, having the stick nearly all the way up, and having turned it almost 90
degrees before it tipped back and sat on its ballast. It stopped traffic all
day untill a Demag C36 was brought in to set it right again.
Paul
|
|
Message has 1 Reply:
Message is in Reply To:
8 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
