To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 10628
    Pneumatic problems —Chris Pritchard
   Hey guys, I'm a bit in a pickle here. I was dismantling my 8042 Universal pneumatic set when I went to pull off the tube off the bottom inlet (The tube was pretty much glued in. It was a non-lego tube), the whole thing snapped off!! After (...) (21 years ago, 10-Jun-03, to lugnet.technic)
   
        Re: Pneumatic problems —Kevin L. Clague
   (...) I don't think that flex system hose is the right thing to try. You might sacrifice a pneumatic T to replace the nipple. I've had good luck with that and epoxy. (...) Kevin (21 years ago, 10-Jun-03, to lugnet.technic)
   
        Re: Pneumatic problems —Jan-Tore Skålvik
     Just contact lego, and they will send you a replacement. use the damaged one for fun! regards jt "Kevin L. Clague" <kevin_clague@yahoo.com> wrote in message news:HGA3o5.4y3@lugnet.com... (...) off the (...) non-lego (...) was I (...) Then I (...) I (...) (21 years ago, 10-Jun-03, to lugnet.technic)
    
         Re: Pneumatic problems —Chris Pritchard
     (...) How do I do that? (...) Who knows? maybe glue the bottom one off, and try using it as a compresser!:) I am trying a different glue this time. I am trying JB weld. It's starting to look hopeful for now. Chris Pritchard (...) (21 years ago, 10-Jun-03, to lugnet.technic)
    
         Re: Pneumatic problems —Jan-Tore Skålvik
     try the local office, in your country best regards jt "Puffie40" <puffie40@hotmail.com> wrote in message news:HGADH0.1oDM@lugnet.com... (...) compresser!:) (...) starting to (...) off the (...) non-lego (...) did was I (...) Then I (...) I left (...) (21 years ago, 10-Jun-03, to lugnet.technic)
   
        Re: Pneumatic problems —Chris Pritchard
   (...) Try the pneumatic T? Could work, since I tried first to glue the broken inlet tube into the hole. That time, it did stick. Unfortuatly, I wanted it a bit longer, So that's where the flex tube comes in. I tried a different epoxie this time. I (...) (21 years ago, 11-Jun-03, to lugnet.technic)
   
        Re: Pneumatic problems —Chris Pritchard
   (...) Ack. Guess I spoke too soon. I was just playing with it when it popped out (AGAIN! :)) I'll try the T, But i'll need to get a couple. Luckily they're cheap :) Chris Pritchard (21 years ago, 11-Jun-03, to lugnet.technic)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR