Subject:
|
Re: Pneumatic problems
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Tue, 10 Jun 2003 18:36:05 GMT
|
Viewed:
|
1179 times
|
| |
|
|
In lugnet.technic, Chris Pritchard wrote:
> Hey guys, I'm a bit in a pickle here.
>
> I was dismantling my 8042 Universal pneumatic set when I went to pull off the
> tube off the bottom inlet (The tube was pretty much glued in. It was a non-lego
> tube), the whole thing snapped off!!
>
> After dismantling the cyilendar, I am trying to fix it up. What I did was I
> took a 1/8" drill bit and, turning it by hand, drilled a small hole. Then I
> took a piece of flex system tubing, and now I'm trying to Epoxy it in. I left
> it overnight, and I put a piece of tubing on it, and when I pulled the tube off,
> the flex tube I glued on came with it!
>
> And that's where I am now. I am retrying epoxying it back in. I am using
> Lepage 5 min epoxy. any suggestions, or do I need to use a stronger glue?
I don't think that flex system hose is the right thing to try.
You might sacrifice a pneumatic T to replace the nipple. I've had good luck
with that and epoxy.
>
> Thanks for ANY suggestions,
>
> Chris Pritchard
Kevin
|
|
Message has 2 Replies:
 | | Re: Pneumatic problems
|
| Just contact lego, and they will send you a replacement. use the damaged one for fun! regards jt "Kevin L. Clague" <kevin_clague@yahoo.com> wrote in message news:HGA3o5.4y3@lugnet.com... (...) off the (...) non-lego (...) was I (...) Then I (...) I (...) (21 years ago, 10-Jun-03, to lugnet.technic)
| | | Re: Pneumatic problems
|
| (...) Try the pneumatic T? Could work, since I tried first to glue the broken inlet tube into the hole. That time, it did stick. Unfortuatly, I wanted it a bit longer, So that's where the flex tube comes in. I tried a different epoxie this time. I (...) (21 years ago, 11-Jun-03, to lugnet.technic)
|
Message is in Reply To:
| | Pneumatic problems
|
| Hey guys, I'm a bit in a pickle here. I was dismantling my 8042 Universal pneumatic set when I went to pull off the tube off the bottom inlet (The tube was pretty much glued in. It was a non-lego tube), the whole thing snapped off!! After (...) (21 years ago, 10-Jun-03, to lugnet.technic)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
