 | | Re: New Gear Boxes and Motor Systems
|
|
Nice motor and gear cases. I would like a few of them :) First I have a few question: 1. What is the small grooves beside the axelholes? If you look closly too all three pieces you will see some small grooves in the casing around the outside of the (...) (21 years ago, 31-May-03, to lugnet.technic)
|
| |
| | Re: New Gear Boxes and Motor Systems
|
|
(...) There is a groove around the axleholes or a larger hole. The inside of this larger hole has small teeth on it. Interesting but I am not sure of its use since an axle will connect to the other pieces. It could be a sleeve for another kind of (...) (21 years ago, 31-May-03, to lugnet.technic)
|
| |
| | Re: New Gear Boxes and Motor Systems
|
|
(...) As i was looking at the picutres, I was thinking: "Where have I seen something lioke that before?". And then I realised: (URL) end of that piece looks a lot like the teeth in those new pieces. I only have piece 41681, and not the piece that it (...) (21 years ago, 1-Jun-03, to lugnet.technic)
|
| |
| | Re: New Gear Boxes and Motor Systems
|
|
"Trevyn Watson" <4tee2@rogers.com> wrote in message news:HFtDoq.A9v@lugnet.com... (...) too (...) the (...) attached (...) I don't have any of those pieces, but on #8558-1: Cahdok and Gahdok I found this piece (URL) look like the counterparts for (...) (21 years ago, 1-Jun-03, to lugnet.technic)
|
| |
| | Re: New Gear Boxes and Motor Systems
|
|
(...) I also have the new 4094 Inventor set. After disassembling the 90 degree gearbox, and comparing the grooves with the new clicky joints of (URL) #8558-1 Cahdok and Gahdok, here are some observations: 1. The grooves LOOK similar to part (URL), (...) (21 years ago, 2-Jun-03, to lugnet.technic, lugnet.org.ca.rtltoronto)
|
| |
| | Re: New Gear Boxes and Motor Systems
|
|
(...) Oh, how sad, you just lost your masters. Sorry. :: revoke masters wand appears :: Iain (21 years ago, 2-Jun-03, to lugnet.technic, lugnet.org.ca.rtltoronto)
|
