|
| | Re: Aviation Tractor MOC
|
| (...) actually (...) I tried it "raw" without any controllers onto the excavator handset compressor/controller and it was *seriously* better than the 8.4V PP3 I had been using before. Of course with the PP3 there will be current issues, but even so (...) (22 years ago, 17-Jun-02, to lugnet.technic)
| | | | Re: Aviation Tractor MOC
|
| (...) How about crazy adults with a thirst for more power? I used to run my old 4.5v motors with a 12v power source. They still work fine today ;-) -TJ (frequent sufferer of Tim "the Toolman" Taylor syndrome <insert manly grunting noise>) (22 years ago, 17-Jun-02, to lugnet.technic)
| | | | Re: Aviation Tractor MOC
|
| There are two issues here. 1. Can the motors sustain more than 9 volts without damage? If I was TLC designing motors for use by kids, I'd make sure there was a large safety margin. New batteries are typically 0.1 - 0.2 volts above their nominal 1.5 (...) (22 years ago, 17-Jun-02, to lugnet.technic)
| | | | Re: Aviation Tractor MOC
|
| Hi all, (...) This reminds me of a series of vehicles that my friend Robin and I made, oh, 15 or so years ago now. We were building remote-controlled cars, using a bunch of batteries taped together for power, and a car speedometer cable to steer (...) (22 years ago, 17-Jun-02, to lugnet.technic)
| | | | Re: Aviation Tractor MOC
|
| Yes, nice job. Well done! (...) If you're going for a real power puller, then a ratio of 24:1 sounds good. But beware! You'll be getting into gear-breaking torques. Be sure to use the new style 24t gears, if you should need 24t gears. I agree with (...) (22 years ago, 17-Jun-02, to lugnet.technic)
| |