 | | Re: An OrthoGlide Mill
|
|
Thanks for your comments Rob. The crossed rubber belts are a last ditch attempt to remove the backlash from the joints. The use of friction pins caused the joints to become so stiff that the platform would not follow the action of the arms. I found (...) (22 years ago, 7-May-02, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: Cutting Lego, any Lego ...
|
|
(...) In support of this, when I made my silver champ, I found that a piece of corrugated tubing was missing. Some time later (about six months) I phoned up Lego and asked if they could send me my missing piece. As the model was packed away, I could (...) (22 years ago, 7-May-02, to lugnet.technic)
|
| |
| | Re: An OrthoGlide Mill
|
|
Beautiful! I saw that page on parallemic as well... Looks like you did a good job making the lego version! I liked the multiple worm gear setup you used to take up the backlash. Just a couple of questions... What are the crossed rubber bands for? Do (...) (22 years ago, 7-May-02, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: MoTeC rule question.
|
|
I've read all the posts on this subject and in my mind all the arguments reinforce my idea of a two tier Motec. I've had another thought since my earlier post. Purists who wanted to compete against modified models could easily enter the modified (...) (22 years ago, 7-May-02, to lugnet.technic)
|
| |
| | Re: Cutting Lego, any Lego ...
|
|
There are times when a part must be cut to length. The only offence here is pretending that you did not. This drives others insane when they try to reproduce your MOC. Admit it and document it. -- Bob Fay THE SHOP (URL) agullo" (...) (22 years ago, 7-May-02, to lugnet.technic)
|
