 | | Re: springless pneumatic pump
|
|
heheh I like it! it is justified! I'm gonna go buy some right now! Thanks for the good reasoning. =) Tom Heverly (...) (24 years ago, 2-May-01, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: springless pneumatic pump
|
|
(...) You have failed to point out that moving involves a lot of heavy lifting. This can be reduced significantly by placing heavy objects on air-cushioned platforms. Air-cushioned platforms require air pumps. Purchase justified. Matthias Jetleb (...) (24 years ago, 1-May-01, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: Small Axle
|
|
"Steven Lane" <Steveroblane@aol.com> wrote in message news:GCMJw0.ErM@lugnet.com... (...) Downloading from Napster? Thou naughty boy! Duq (24 years ago, 1-May-01, to lugnet.technic)
|
| |
| | Re: Small Axle
|
|
(...) It's not the same notch, their different. The one on the motor is rounded while the one on the 2L axle is set at a right angle. Steve (24 years ago, 1-May-01, to lugnet.technic)
|
| |
| | Re: Small Axle
|
|
Its been my experience that the notches are used to "click" them into place. Example: slowly put one into a full gray (or red) bush, you can "feel" it "click" or "lock" into place. It does the same thing with axle connectors too. Hope this helps. -- (...) (24 years ago, 1-May-01, to lugnet.technic)
|
| |
| | Re: Small Axle
|
|
(...) Nope. Ever try running a rubber band in it though? James (24 years ago, 1-May-01, to lugnet.technic)
|
| |
| | Re: Small Axle
|
|
(...) So now we just have to find out why the <part:6216m 4.5V motor> (as in <set:5101>) has the same notch on it's output shaft. (to pull the motor out? :) - David (24 years ago, 1-May-01, to lugnet.technic)
|
| |
| | Re: Small Axle
|
|
Boy are those little notches handy, too! I remember noticing the notches very soon after I left my dark ages. Most of my 2 long axles from before my dark ages have tooth marks from being removed from some other Technic piece. And I REALLY dislike (...) (24 years ago, 1-May-01, to lugnet.technic)
|
| |
| | Re: springless pneumatic pump
|
|
(...) Yea, it does seem to work well manually, I was just trying to get some of that mechnized action out of it. It's all about the tinkerin'. =) I saw the pumps on the Dacta site, but I'm afraid the finance committee (wife) has put a spending (...) (24 years ago, 1-May-01, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: springless pneumatic pump
|
|
(...) LOL yup...if you have a fast and powerful hand you can create a ton of pressure within seconds with this... BTW I recently acquired a pack of two small pumps for $10US from the Dacta site...so this might be a solution if you're looking for the (...) (24 years ago, 1-May-01, to lugnet.technic, lugnet.robotics)
|
