 | | Never seen this model before
|
|
Hi together! I saw some new models for september so far, but at this link there are some sort of bionicle machines which are new to me and which could not be seen on the official legosite: (URL) looks like machines with remote control (according to (...) (26 years ago, 12-Apr-01, to lugnet.technic.bionicle)
|
| |
| | (canceled)
|
|
|
| |
| | Re: The bodge and it's use in Technic Construction
|
|
(...) And, once, the ex-President asked for a quickie, thinking he was ordering a 'keesh'(quiche?) old joke... --Electro-- (26 years ago, 12-Apr-01, to lugnet.technic)
|
| |
| | Re: The bodge and it's use in Technic Construction
|
|
(...) Here's one: inserting the studs of one beam into the axle holes of a Technic beam. They're not designed to fit properly, and the parts will actually deform over time if left long enough. (26 years ago, 12-Apr-01, to lugnet.technic)
|
| |
| | Re: Pneumatic Pump Testing Goes Hi Tech
|
|
(...) Thanks for the information. I'm going to see if I can get hold of one of these... (...) I use pneumatics mainly where brute strength is needed rather than smooth motion, such as the raising/lowering mechanism on a crane (although this (...) (26 years ago, 12-Apr-01, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Motor with Gear Reduction ??!??
|
|
(...) the (...) Try this page: "(URL) couldn't fit it in one line so some copy&paste should be used. (Looking at the table, though, I think 60 rpm is too slow for the new geared motor) - David (26 years ago, 12-Apr-01, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Pneumatic Pump Testing Goes Hi Tech
|
|
(...) Thanks for the identification of the tire pressure gauge. I reckon the stores will soon be doing a brisk trade in them. But I would hesitate to use the word *calibrate* - the pressure sensor is a far more delicate device than the tire gauge. (...) (26 years ago, 12-Apr-01, to lugnet.robotics, lugnet.technic, lugnet.build, lugnet.dacta)
|
| |
| | Re: Pneumatic Pump Testing Goes Hi Tech
|
|
(...) Methinks it'll be muscle wire or air muscle or something akin... Well, if you don't need the pneumatics any more, how about "donating" them to me :-) (26 years ago, 12-Apr-01, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: looking for inventories of 8064 & 9v power pack
|
|
(...) have (...) Hi Jonathon If you build the 4 models in the instructions, re-using parts if you've already used them, or adding from your collection as required, you should end up with a close approximation of the set's inventory. I doubt if Lego (...) (26 years ago, 12-Apr-01, to lugnet.technic, lugnet.db.inv)
|
| |
| | Re: looking for inventories of 8064 & 9v power pack
|
|
(...) I need an inventory of the whole set so that I can identify what parts I dont have that are needed for an 8064 so that I can obtain them. (26 years ago, 11-Apr-01, to lugnet.technic, lugnet.db.inv)
|
