 | | Re: The bodge and it's use in Technic Construction
|
|
The more precise your model, the more washers and shims are needed to make things work per your design. The worm gear always needs a washer or two depending how many you use end for end. I have even used plastic wrap between beams to get that "just (...) (26 years ago, 9-Apr-01, to lugnet.technic)
|
| |
| | The bodge and it's use in Technic Construction
|
|
I'm about to utilize a bodge to stop the teeth slipping on a dif case, I was wondering if anyone else had to alter their designs due to deficiencies in design of actual Technic components? Steve (26 years ago, 9-Apr-01, to lugnet.technic)
|
| |
| | Re: Yet another use for 7106
|
|
(...) Are you planning to make an actual WORKING model then? Steve Lane (26 years ago, 9-Apr-01, to lugnet.technic)
|
| |
| | Re: Bob Fay
|
|
I am slowly collecting Black 1x8 wings for this purpose, looking foward to getting them attached to the spine.....Thanks...Eric (...) (26 years ago, 9-Apr-01, to lugnet.technic)
|
| |
| | Re: Yet another use for 7106
|
|
Yeah, I knew what you meant, that's why I said "its not perfect" in the original post. It'd be nifty if the ridges were on the outside, but then the pod would look a bit silly, and the ribs would scrape the ground below the blade. I still think it (...) (26 years ago, 9-Apr-01, to lugnet.technic)
|
