 | | Re: 100% LEGO Technic Clock with Electric Drive
|
|
Not content with a clock mechanism that was 12 studs wide, I completely redesigned the reduction geartrain yesterday, resulting in a mechanism that is only 8 studs wide. There is much less friction in this new design than in the previous one, so it (...) (18 years ago, 21-Nov-06, to lugnet.technic, FTX)
|
| |
| | 100% LEGO Technic Clock with Electric Drive
|
|
I've spent the past few days refining the design of my (URL) Technic clock>. I've managed to convert it to electric drive (using a 9V micro motor) which enabled me to get rid of the 2-lb. weight and string. This made it possible to further reduce (...) (18 years ago, 19-Nov-06, to lugnet.announce.moc, lugnet.technic, FTX) !!
|
| |
| | Erik's Countach
|
|
Since Erik does not appear to be tuting his own horn, I will do it for him. (URL) appears to have all of the functions of the older supercar designs by TLC and it looks just like a Countach. Good work Erik! (18 years ago, 17-Nov-06, to lugnet.technic)
|
| |
| | Re: Pneumatic compressor
|
|
(...) So that's self-and-dave proclaimed guru... Dave K (18 years ago, 16-Nov-06, to lugnet.org.ca.rtltoronto, lugnet.technic)
|
| |
| | Re: Pneumatic compressor
|
|
(...) Self proclaimed guru.... ;^) (...) (18 years ago, 15-Nov-06, to lugnet.org.ca.rtltoronto, lugnet.technic)
|
| |
| | Re: Steering Configuration on Large Vehicle - Where to Begin?
|
|
(...) Hi Pat, Well I think the 8860 is a great place to start. That configuration could hold a lot of weight, do you have any idea how much you need to support? (URL) (18 years ago, 13-Nov-06, to lugnet.technic)
|
| |
| | Steering Configuration on Large Vehicle - Where to Begin?
|
|
Hi Technic Gurus! I'm starting what I consider to be an ambitious project -- My area of "expertise" (if you will) is Classic Space, but I am considering a large space vehicle with potential dimensions of 22 studs width and between 64 and 80 studs (...) (18 years ago, 13-Nov-06, to lugnet.technic)
|
| |
| | Re: If you're going to use the LEGO capacitor....
|
|
(...) Nice Video Dave. I assume you shot the video at the Hobby show? If you listen closely, you can hear Chris Magno's laugh and faintly hear Janey talking (towards the end of the clip). Ben. (18 years ago, 12-Nov-06, to lugnet.org.ca.rtltoronto, lugnet.technic)
|
| |
| | Re: Pneumatic cylinder/pump
|
|
Well I've just built this, and I can say that with a minor modification the pump works fine. You need to join the outputs from the two switches depicted through a third switch to prevent pressure being lost through the exhaust port. However, since (...) (18 years ago, 12-Nov-06, to lugnet.technic)
|
| |
| | Re: If you're going to use the LEGO capacitor....
|
|
(...) I did! Thanks also for sharing you new compressor with RC motor... Philo (18 years ago, 10-Nov-06, to lugnet.org.ca.rtltoronto, lugnet.technic)
|
