|
|
 | | Re: Crab steering idea
|
| (...) There's a couple of problems with that technique: The clutch gear has a lot of inherent backlash, which will make the steering not very responsive you have to make sure the wheels are centred when you switch the clutch to get back to straight (...) (20 years ago, 29-Oct-04, to lugnet.technic, FTX)
| | | | | Re: 8865 and 8475
|
| (...) Once agian I made the mistake of using hte 'higher speed' one, just like the last robot event. IN the 8448 that was just fine, but these are bigger tyres and a heavier chassis, so it takes a little bit to get up to speed. You can barely see' (...) (20 years ago, 28-Oct-04, to lugnet.org.ca.rtltoronto, lugnet.technic)
| | | | | Part number for old Technic piston?
|
| I'm doing a cross-check on a part number. Can anyone confirm the number of the older, square Technic piston? Peeron shows the number for this part as 3652: (URL) shows the number as 3562: (URL) seems likely that the number on Technica is a typo, but (...) (20 years ago, 28-Oct-04, to lugnet.db.brictionary, lugnet.technic)
| | | | | Re: 8865 and 8475
|
| Are those the RC Motors tucked in there somewhere? If so, which axel hole are you driving it with? (...) (20 years ago, 28-Oct-04, to lugnet.org.ca.rtltoronto, lugnet.technic)
| | | | | Re: Crab steering idea
|
| Ross- Looking at Nathan's crab design, I realized that the center steering mechanism resembles a differential. Realizing this I came up with a sketch (since that's all I'm able to do until I move into a house and open my legos) using a differential (...) (20 years ago, 28-Oct-04, to lugnet.technic, FTX)
|
|
