 | | Re: How to get non-circular movements?
|
|
(...) question at any of them, as far as I can see. Could you elaborate on how this applies? Thanks, - Joe (20 years ago, 23-Aug-04, to lugnet.technic)
|
| |
| | Re: How to get non-circular movements?
|
|
(URL) regards pixel (20 years ago, 23-Aug-04, to lugnet.technic)
|
| |
| | Re: How to get non-circular movements?
|
|
(...) Ah, I see. The pivot point must be free to slide on the arm (er, vice versa) as well. I think that's the key bit I was missing last night. (...) devices in my Technic models. Best, - Joe (20 years ago, 23-Aug-04, to lugnet.technic)
|
| |
| | Re: How to get non-circular movements?
|
|
(...) (rather than operated by hand) will be nontrivial. But should be possible. Thanks for the pointer! Best, - Joe (20 years ago, 23-Aug-04, to lugnet.technic)
|
| |
| | Re: pneumatic help
|
|
(...) Hi Vineet, I'll see if I can help. Your desciption "control four pneumatic pistons individually, and simultaneously having them controlled by one master switch" does not seem to match the second diagram. The primary reason is that you have (...) (20 years ago, 23-Aug-04, to lugnet.technic)
|
