 | | Re: Ladies and gentlemen...
|
|
(...) Yeah, putting them straight is the real trick, isn't it. My plan is to use springs (shock absorbers) which hopefully will align the mechanism centrally in this brief moment when gear shift is in "idle" position. For now it's all theory, (...) (20 years ago, 22-Jun-04, to lugnet.technic, FTX)
|
| |
| | Re: Ladies and gentlemen...
|
|
(...) Ahhhhhh! I actually looked at that technique, and it works OK but you have to make sure the wheels are straight when you switch it! Instead I investigated (URL) this technique> but have yet to use it in a MOC. ROSCO (20 years ago, 21-Jun-04, to lugnet.technic, FTX)
|
| |
| | Re: Instant Mini Air Compressor using RC Buggy Motor
|
|
(...) Or someone design a LEGO cooling system ;) ROSCO (20 years ago, 21-Jun-04, to lugnet.technic, FTX)
|
| |
| | Re: Instant Mini Air Compressor using RC Buggy Motor
|
|
(...) Thanks, but actually the design suggested of itself. Normally, one would use the outer motor output shaft. But I was struck by the exact geometry using the inner motor output shaft and the small pump. Is it a fortuitous coincidence or is it an (...) (20 years ago, 21-Jun-04, to lugnet.technic, FTX)
|
| |
| | Re: Ladies and gentlemen...
|
|
(...) Thank you, Rosco. (And thank you Eric for the earlier post). Well, gear selectors were just a necessity, but worked out well. I don't think more motors can be squashed into frame only 8 studs wide. I'm planning to use similar system for (...) (20 years ago, 21-Jun-04, to lugnet.technic, FTX)
|
