 | | Re: SSClagorpion - Compressor
|
|
Are you going to make sure that all your control logic is done with small pistons? That would seem to save a lot of air, and thus perhaps also speed the system up quite a bit. (20 years ago, 2-Jun-04, to lugnet.technic)
|
| |
| | Re: SSClagorpion - Compressor
|
|
(...) Not necessarily. If they're compressing in a rotating series, your output at any given moment is much smaller than if they were going off all at the same time, and the more positions you can get in the series, the steadier your stream of (...) (20 years ago, 2-Jun-04, to lugnet.technic)
|
| |
| | Re: SSClagorpion - Compressor
|
|
(...) Well that depends on how they're routed down the line. If they all pass through a single hose at any point, bang goes your bandwidth. ROSCO (20 years ago, 2-Jun-04, to lugnet.technic)
|
| |
| | Re: SSClagorpion - Compressor
|
|
I finally had some LEGO time. Given the rate that RC Racer motors suck up current, Using two pumps with two motors and two battery packs, is about the best I can do. I did some measuring and calculating (only outer diameters :^( A large piston has (...) (20 years ago, 1-Jun-04, to lugnet.technic)
|
| |
| | Re: LEGO on TechTV
|
|
(...) I'm not sure how well this will work. I just spoke with them, and in addition to the segment, the robots will be playing against people (staff & audience) during the entire show. How big is a one hour show, when converted to mpeg? :) Steve (...) (20 years ago, 1-Jun-04, to lugnet.mediawatch, lugnet.robotics, lugnet.technic)
|
