To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 12723
12722  |  12724
Subject: 
Re: SSClagorpion - Compressor
Newsgroups: 
lugnet.technic
Date: 
Wed, 2 Jun 2004 00:01:31 GMT
Viewed: 
19534 times
  
In lugnet.technic, Kevin L. Clague wrote:
Also, as David pointed out, the three compressing pumps have three times the
number of ports, so they have three times the bandwidth.

Well that depends on how they're routed down the line. If they all pass through
a single hose at any point, bang goes your bandwidth.

ROSCO



Message has 1 Reply:
  Re: SSClagorpion - Compressor
 
(...) Not necessarily. If they're compressing in a rotating series, your output at any given moment is much smaller than if they were going off all at the same time, and the more positions you can get in the series, the steadier your stream of (...) (20 years ago, 2-Jun-04, to lugnet.technic)

Message is in Reply To:
  Re: SSClagorpion - Compressor
 
I finally had some LEGO time. Given the rate that RC Racer motors suck up current, Using two pumps with two motors and two battery packs, is about the best I can do. I did some measuring and calculating (only outer diameters :^( A large piston has (...) (20 years ago, 1-Jun-04, to lugnet.technic)

300 Messages in This Thread:
(Inline display suppressed due to large size. Click Dots below to view.)
Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR