 | | LEGO design patterns... you know, there's a book in that, I'm sure of it!
|
|
Adder/Subtractor based mechanisms Synchro Drive Pneumatic Circuit Ratchet Bracing Lego structures with cross beams Ganging multiple pneumatic switches onto a single piston for control ... the list goes on and on and on... There's a lot of stuff out (...) (21 years ago, 22-Jun-03, to lugnet.technic)
|
| |
| | Re: The latest rage in pneumatic computing
|
|
(...) Okay... I've added arrowheads to each line showing air flow direction. The switches are set up so that the center port is the conventional inlet, and the top and bottom ports the outlets. I say conventional, because I don't always use it that (...) (21 years ago, 22-Jun-03, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: The latest rage in pneumatic computing
|
|
(...) Arrow heads showing which direction you expect the air to flow (not including release) would be helpful also. I've tried to figure it out, but I've not had a lot of luck. (...) (21 years ago, 22-Jun-03, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: The latest rage in pneumatic computing
|
|
(...) Well, I didn't invent the single piston gate. I give credit where credit is due. As I said in a previous post. Your single piston AND gate design was inspirational. I talked myself out of this in the past because I could not figure out how to (...) (21 years ago, 22-Jun-03, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: The latest rage in pneumatic computing
|
|
Wow. Thank you so much for the acknowledgement, Kevin. I am genuinely flattered. I've got a bitmap made of the schematic for my 13 switch full adder. It's strictly representative, and not meant to imply how the switches would be positioned in the (...) (21 years ago, 22-Jun-03, to lugnet.technic, lugnet.robotics)
|
