 | | 2 x4 brick down drain
|
|
One 2 x4 brick escaped my collander to go down the drain in my bathroom sink. Has anyone else had this experience? My sink has not slowed- yet... Will it just flush on through? Is this going to cause me problems later? I am not looking forward to at (...) (24 years ago, 19-May-01, to lugnet.general, lugnet.storage)
|
| |
| | Re: Drawers vs tilt-bins and scratching?
|
|
(...) I use pull-out drawers (IRIS) and don't have that problem. The drawers are big enough that you can pull one out 1/3 of the way and the one below it 2/3 of the way, and access both. You do sometimes find the drawer you want blocked, but if you (...) (24 years ago, 19-May-01, to lugnet.storage)
|
| |
| | Re: Drawers vs tilt-bins and scratching?
|
|
(...) In a tilt-bin setup, bins get opened only once (they stay open) no matter how many times parts are taken from them. They can also be removed. In a tray system, as at TLC, the entire drawer is a compartmentalized tray (aprox 24x30x3). It gets (...) (24 years ago, 19-May-01, to lugnet.storage)
|
| |
| | Re: Drawers vs tilt-bins and scratching?
|
|
(...) I'd like to hear more about this if it's not confidential. When I am free building or designing something new (as opposed to doing a production run where I am working from a parts list) I don't always know how much of what I will end up (...) (24 years ago, 19-May-01, to lugnet.storage)
|
| |
| | Re: Drawers vs tilt-bins and scratching?
|
|
(...) I don't think the issue of tilt shift causing wear is one worthy of consideration unless it's the only consideration. That said, I could argue that under certain working conditions, there would actually be less shifting with a tilt system. But (...) (24 years ago, 19-May-01, to lugnet.storage)
|
