 | | Re: modular components for sharing designs
|
|
(...) <snip> (...) <snip> (...) Some standards (they have never been written until this point) that I use when building large ships are: Beds -Spartan 2 x 5 -Standard 3 x 6 -Luxury 6 x 6 Hallways & Corridors - 4 studs wide minimum, 5 bricks high (...) (24 years ago, 14-Feb-01, to lugnet.space, lugnet.build)
|
| |
| | Re: modular components for sharing designs
|
|
(...) Next to a wall, I find 3x5 to be a better size for a spartan bed. Annoying to build, but you can fit a minifig on it without half of him hanging off. :) 2x5 is fine if it sticks out from a wall or something like that. (...) This, I think, (...) (24 years ago, 14-Feb-01, to lugnet.space, lugnet.build)
|
| |
| | Re: modular components for sharing designs
|
|
(...) I have the 2 X 5 bed next to a window, so the 'fig can hang off into it. The other problem with the 5 long bed is that the 'fig is a little to tall to properly lay down. I usually insert a 1 x 2 x 2 panel into the wall to help out. I'm (...) (24 years ago, 14-Feb-01, to lugnet.space, lugnet.build)
|
| |
| | Re: modular components for sharing designs
|
|
(...) I did something fairly similar, which is why I wound up with the x5 part of it. Why I did it can almost be seen in: (URL) yellow bunk (and the black one under it) is set under/into one of the arctic-base grey wall/window segments. Helps get it (...) (24 years ago, 15-Feb-01, to lugnet.space, lugnet.build)
|
| |
| | Re: modular components for sharing designs
|
|
(...) <snip> (...) Yikes! (...) My current models has a combination head/shower. If I get some time, I'll CAD it up. The whole thing fits in a 4 X 8 footprint. In the mean time check out Paul's vehicle. (URL) taken a few ideas from there. (...) (...) (24 years ago, 15-Feb-01, to lugnet.space, lugnet.build)
|
| |
| | Re: modular components for sharing designs
|
|
(...) OK. I've taken a few minutes to mock-up the head/shower that I am using. I hope this helps. (URL) (24 years ago, 15-Feb-01, to lugnet.space, lugnet.build)
|
