 | | Re: Using Vision Command as a Smart Sensor
|
|
(...) I didn't check this out yet, but i guess it does !!?!! (...) Nice to hear ! Thanks ! Rainer (24 years ago, 6-Dec-00, to lugnet.robotics, lugnet.robotics.vc)
|
| |
| | Re: Using Vision Command as a Smart Sensor
|
|
"Rainer Balzerowski" <balze2@gmx.net> wrote in message news:G55v2z.LqB@lugnet.com... (...) or (...) for one (...) I didn't realize VC tried to compensate for the RCX program. I'll fix that comment. Do you think the Spin Left 1.0s command in the (...) (24 years ago, 6-Dec-00, to lugnet.robotics, lugnet.robotics.vc)
|
| |
| | Re: Using Vision Command as a Smart Sensor
|
|
In lugnet.robotics, Michael Gasperi writes: hoped would be developed with Vision Command. Thanks for the posting. (...) Hi folks, i do it in a task like this : int global_message; task Read_VC_Messages () { int j; int local_message = 0; (...) (24 years ago, 6-Dec-00, to lugnet.robotics, lugnet.robotics.vc)
|
| |
| | Re: Using Vision Command as a Smart Sensor
|
|
I just used one Message. I still don't know how to do your test program. This will start and stop the motor as long as motion is detected in area 2. task main() { while(true) { if (Message()== 2) { OnFwd(OUT_A); Wait(100); Off(OUT_A); } } } -- Bob (...) (24 years ago, 6-Dec-00, to lugnet.robotics, lugnet.robotics.vc)
|
| |
| | Re: Using Vision Command as a Smart Sensor
|
|
"Bob Fay" <rfay@we.mediaone.net> wrote in message news:G55s5H.CHz@lugnet.com... (...) Were you able to make it work with NQC? If it was, I'd like to see the code. Despite the association with my friend Dave Baum, I don't use NQC. (24 years ago, 6-Dec-00, to lugnet.robotics, lugnet.robotics.vc)
|
