 | | Re: VC vs Studio cam question
|
|
Jan Nouza <jan.nouza@vslib.cz> wrote in message news:G9DG0s.HwI@lugnet.com... (...) and (...) cam (...) I haven't seen any noise effects from the Studios camera when close to motors. Personally I think they used the fancy clear shielded cable just (...) (23 years ago, 27-Feb-01, to lugnet.robotics.vc)
|
| |
| | Re: VC vs Studio cam question
|
|
Those who built moving applications with the VC cam know that the very stiff cable complicates the design and limits practical usage. My opinion is that the LEGO added this heavy cable in order to avoid interference with elmag noise produced by (...) (23 years ago, 26-Feb-01, to lugnet.robotics.vc)
|
| |
| | Re: Problems by using VC as a smart sensor
|
|
Hi Maze, (...) The software only sends a message if a region gets active and not if a region gets inactive ! Try something like this: switch (message) { case 1 : OnFwd(Motor_Left); OnFwd(Motor_Right); Wait(10); // let the motors turn a while break; (...) (23 years ago, 24-Feb-01, to lugnet.robotics.vc)
|
| |
| | Problems by using VC as a smart sensor
|
|
Hello everybody, I want that my robot goes ahead, ONLY as long as the first region is active. and goes left ONLY when the second is active, goes right ONLY when 3th is active and goes back ONLY as long as the 4th is active. But it dosent functure. (...) (23 years ago, 24-Feb-01, to lugnet.robotics.vc)
|
| |
| | Re: vision command with Visual Basic
|
|
I think you are looking for the Wauters Kris ActiveX software: (URL) Rojas" <ge-rojas@uniandes.edu.co> wrote in message news:G91ByF.JGz@lugnet.com... (...) (23 years ago, 20-Feb-01, to lugnet.robotics.vc)
|
| |
| | vision command with Visual Basic
|
|
Hi!! any know when i can to see any code example to program the vision command with Visual Basic? thanks!!! (23 years ago, 20-Feb-01, to lugnet.robotics.vc)
|
| |
| | VC & K6 : (
|
|
Hello, I finally took my VC into work and installed it on a test machine I have in my cube and it worked fine on an old Dell P166. I found some reference that said Logitech Cams might not work with certain K6 processors and appearently my K6-300 is (...) (23 years ago, 1-Feb-01, to lugnet.robotics.vc)
|
| |
| | Re: VC / studio question
|
|
Bob Fay <rfay@we.mediaone.net> wrote in message news:G7y9qC.A2z@lugnet.com... (...) length (...) I'd say it was 16 feet also. However, the Studio camera's cable is not as heavy or stiff at the VC one. I'd think it would be better for pulling behind (...) (23 years ago, 30-Jan-01, to lugnet.robotics.vc)
|
| |
| | Re: VC / studio question
|
|
I know the cable is 16 feet on the Vision Command. What is the cable length on Studio? -- Bob Fay California, USA rfay@we.mediaone.net (URL) (23 years ago, 30-Jan-01, to lugnet.robotics.vc)
|
| |
| | Thanks for the quick answer!! (n/t)
|
|
(23 years ago, 29-Jan-01, to lugnet.robotics.vc)
|
