| |
In lugnet.robotics.rcx, Steve Hassenplug wrote:
>
> Thanks for posting this. I've been trying to figure out how to do that, but I
> don't know enough about the IR messages and baud control of BrickOS to do it
> myself.
>
> >
> > // check for channel assignment packet
> > // format: 100100CC 1111SSSS
> > // C = channel number (1 to 3)
> > // S = checksum
> > if ( (spy_packet[0] & 0xFC) == 0x90 &&
> > (spy_packet[1] & 0xF0) == 0xF0 )
> > channel = spy_packet[0] & 0x03;
> > }
>
> I don't know if this is printed anywhere, but here's some more info about the
> Spybot remotes:
>
> "in addition to the channels 1, 2 and 3, there are
> three more channels 4, 5 and 6 (which you select in Setup mode by holding
> down the lower left buttion (SHIFT) when pressing the normal channel buttons"
As cool as this sounds, it's not right. :( Sorry about that.
There are just the two bits (like Mark said above).
See, this is why I haven't been able to get my Spybot remote to work with my
RCX. :)
Steve
|
|
Message has 1 Reply:
Message is in Reply To:
17 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
