| |
In lugnet.robotics.spybotics, Mark Riley writes:
> After doing a little more sleuthing, I was able to find out how to
> process incoming IR and VLL messages. And yes, thankfully, VLL
> decode is built into the firmware!
>
> The following is some SpyBot MindScript code that will handle both
> incoming VLL and IR messages.
Hi Mark,
am I right, all you have described above only works with a RCX2.0-hardware
cause of the changed IR-interface?
Is there any chance to communicate between Spybot and RCX1.5 (with 2.0
firmware)?
If there is no, I will have to buy a single RCX2.0. Has anyone an idea where
to get one? I could not find it in the lego online-shop.
Thxs and cheers,
Stefan
|
|
Message has 1 Reply:
 | | Re: Spybotics Comms
|
| (...) You already have an RCX 2.0. Aside from printing "RCX 2.0" on the plastic, the RCX in RIS 2.0 is identical to the one included in RIS 1.5. Since you have downloaded the 2.0 firmware, you should be all set. Dave (22 years ago, 11-Dec-02, to lugnet.robotics.spybotics)
|
Message is in Reply To:
| | Re: Spybotics Comms
|
| After doing a little more sleuthing, I was able to find out how to process incoming IR and VLL messages. And yes, thankfully, VLL decode is built into the firmware! The following is some SpyBot MindScript code that will handle both incoming VLL and (...) (22 years ago, 19-Aug-02, to lugnet.robotics.spybotics)
|
12 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
