To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.rcx.robolabOpen lugnet.robotics.rcx.robolab in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / RCX / ROBOLAB / 6
5  |  7
Subject: 
Re: Problems with RCX Robolab and PowerMacs 6400/200 and 5500/225
Newsgroups: 
lugnet.robotics.edu, lugnet.robotics.rcx.robolab, lugnet.robotics.rcx
Date: 
Sat, 20 Nov 1999 21:34:10 GMT
Reply-To: 
suz@media.mit.edu!saynotospam!
Viewed: 
1770 times
  
I'm a user, not engineer, but.. you might want to try this if you
haven't already. I had the same difficulty and went through all the
toubleshooting methods you have.

This is going to sound silly, but has worked for me: With the IR tower
on low setting and RCX brick quite close, facing it, I then shield any
overhead light. You can try it quickly by leaning over to shade the
transmission. If no, or only partial success, use a piece of heavy
dark paper to build a tunnel for the transmission.

I have generally had very poor results in transmitting with these IR
towers. It can be extremely frustrating. Even the above is not a sure
solution. Sometimes after unplugging everything, rebooting, and moving
the objects, just standing over it -- it'll suddenly work. other
times, I'll have done a complete process of elimination with brick,
batteries, tower, cables, system extentions, ports, and machines with
no success. it's quite mysterious.

oh, one conflict I found was related to Palm Pilot software. I have to
disable the serial checker that runs on startup.

good luck.

-Suz.

"Paul E. Rybski" wrote:

Hello,
        I'm teaching an RCX-based programming class using the Robolab
software to a group of 19 4th,5th and 6th graders.  I've been trying to
get the Robolab software installed and running on the Powermac 5500/225s
and 6400/200s owned by the school.  Every time I try to run Robolab and
download firmware or even just test the communication between the
transmitter and the brick, I get an error saying that the macintosh could
not communicate to the RCX and the graphical error display shows a red X
over the transmitter, the cable and the RCX.  However, I do see the little
green LED inside of the transmitter turning on. [...]
        Any advice, words of wisdom or troubleshooting suggestions would
be greatly appreciated.

Thanks!

---
Paul E. Rybski --- http://www.cs.umn.edu/~rybski



Message is in Reply To:
  Problems with RCX Robolab and PowerMacs 6400/200 and 5500/225
 
Hello, I'm teaching an RCX-based programming class using the Robolab software to a group of 19 4th,5th and 6th graders. I've been trying to get the Robolab software installed and running on the Powermac 5500/225s and 6400/200s owned by the school. (...) (25 years ago, 20-Nov-99, to lugnet.robotics, lugnet.robotics.edu, lugnet.robotics.rcx.robolab, lugnet.edu, lugnet.robotics.rcx)

11 Messages in This Thread:







Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR