 | | Re: failure in communicaton between RCX & IR Tower
|
|
I may be stepping out on a limb, but have you tried reformatting the laptop that doesn't work? What about using NQC or the original Lego software to test and make sure its not RoboLab in combination with your laptop that is causing errors. Ok, (...) (23 years ago, 17-Oct-03, to lugnet.robotics.rcx.robolab)
|
| |
 | | Re: failure in communicaton between RCX & IR Tower
|
|
I tested with the same installation, IR tower & rcx module with another laptop (by Dell) built with infrared port, wireless network card, but with no bluetooth built in. They work fine... The problem is more and more leaning over to hardware (...) (23 years ago, 17-Oct-03, to lugnet.robotics.rcx.robolab)
|
| |
 | | Re: usb tower failed in XP!
|
|
Since this subject does not match the possible problem, I started a new thread to reflect the more accurate symptom "failure in communicaton between RCX & IR Tower" (23 years ago, 16-Oct-03, to lugnet.robotics.rcx.robolab)
|
| |
 | | failure in communicaton between RCX & IR Tower
|
|
PC: toshiba - P25 series model with four usb 2.0 ports, an bluetooth/wi-fi capability, w/ infrared port built in as well. IR Tower : usb RCX : 1.0 Symptom: - communication between the ir tower & laptop is fine... verified with the device manager - (...) (23 years ago, 16-Oct-03, to lugnet.robotics.rcx.robolab)
|
| |
 | | Re: usb tower failed in XP!
|
|
After I have done trouble-shooting for hours on my toshiba-laptop, the point of failure seems to be between the ir tower & the rcx...: - the ir tower did insteed install properly... I have verified with the device manager as well. - the (...) (23 years ago, 16-Oct-03, to lugnet.robotics.rcx.robolab)
|