Subject:
|
Re: Help with Terminal Emulator
|
Newsgroups:
|
lugnet.robotics.rcx.pbforth
|
Date:
|
Sat, 20 May 2000 23:51:58 GMT
|
Viewed:
|
1561 times
|
| |
|
|
I think my problem is bounce back noise.
I doubled checked the port settings, started with
a fresh set of batteries, made sure I had a clear buffer,
but what made the difference is where I am doing my programming.
I'm working off of a laptop, and when I'm in my office,
I have problems with the garbage echoing on the screen.
When I'm at home with the same laptop, no problems.
The TCL terminal emulator works great. For some reason,
I am getting extraneous signals at work. I suppose it
could be bounce back or maybe another source of IR signals.
Anyway, Steve, Jeff, thanks for the help. I'll work at
repositioning the IR tower at work to see if I can get
rid of the IR noise.
--Jerry
jweinbe@siue.edu
In lugnet.robotics.rcx.pbforth, Jeffrey Hazen writes:
> Steve Morris wrote:
>
> > Note: The doc doesn't say it but a terminal must be set to
> > 2400,8,N,1 with both software and hardware handshake off.
>
> At first look, I thought this looked like a baud rate problem. But with
> Ralph's program (at least on my machine), you can't really screw up....the
> baud rate is set in rcxutil.tcl, and overrides whatever you do in the
> control panel "ports" applet. That said, it is still probably worth while
> to make sure you're booting your machine with the com settings as Steve
> describes.
>
> Jeff
> jeffrey.hazen@northmill.net
|
|
Message has 1 Reply:
 | | RE: Help with Terminal Emulator
|
| (...) I have run into this too, Jerry. A few especially bothersome noise sources include video cameras, security systems, and remote controls. You might consider covering the RCX and tower with a box or towel... I'm glad the terminal emulator works (...) (25 years ago, 21-May-00, to lugnet.robotics.rcx.pbforth)
|
Message is in Reply To:
| | Re: Help with Terminal Emulator
|
| (...) At first look, I thought this looked like a baud rate problem. But with Ralph's program (at least on my machine), you can't really screw up....the baud rate is set in rcxutil.tcl, and overrides whatever you do in the control panel "ports" (...) (25 years ago, 18-May-00, to lugnet.robotics.rcx.pbforth)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
