| |
In lugnet.robotics.rcx.pbforth, Ralph Hempel writes:
> I've only verified pbForth being uploaded using the commandline
> version of NQC.
>
> In lugnet.robotics.rcx.pbforth, George Lampke wrote:
> > Had NO problem loading original RCX firmware, Firm0309.lgo, with same
> > configuration!! Placement of IR tower was OK.
>
> This is good. Has anyone else out there tried RCXCC to upload the pbForth
> firmware????
Yep - I did, same deal. Three times in a row, pbforth.srec uploaded fine all
the way until the display read 1638 (which I presume is the end of the file)
and then it cut out. I was a bit perplexed, so I re-uploaded firm0309.lgo,
which worked. I then tried just the NQC command line, and it finished
downloading properly.
-- Ian
|
|
Message has 1 Reply:
 | | RE: installation problem!
|
| (...) Ummmm, I think if you use NQC command line, the counter only goes to 1300 or so. I wonder 1f RCXCC is reading the SRECORD file and padding it to 16384 bytes. I wonder if it is actually loading the old firmware. I wonder.... Cheers, Ralph (...) (25 years ago, 29-Jan-00, to lugnet.robotics.rcx.pbforth)
|
Message is in Reply To:
| | RE: installation problem!
|
| (...) I've only verified pbForth being uploaded using the commandline version of NQC. (...) This is good. Has anyone else out there tried RCXCC to upload the pbForth firmware???? Cheers, Ralph Hempel - P.Eng ---...--- Check out pbFORTH for LEGO (...) (25 years ago, 27-Jan-00, to lugnet.robotics.rcx.pbforth)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
