| |
-----Original Message-----
From: George Lampke [mailto:glampke@verinet.com]
Sent: Thursday, January 27, 2000 12:50 PM
To: Ralph Hempel
Subject: Re: installation problem!
You are right Ralph. Using the command line version of NCQ works to load
pbForth firmware, but the RCX Command Center does not work!! Thanks for
the response.
Ralph Hempel wrote:
>
> > Running Windows98. All works well with original RCX firmware and NCQ
> > programs. Was anxious to try out pbFORTH as an alternative!!
> >
> > Unzipped pbforth111.zip and used RCX Command Center to download
> > pbForth.srec. Progress window looked good UNTIL the end. Then a
> > message pops up on my PC -> "Firmware Download failed, try again,..etc".
> > No "4th" displayed on RCX, just familiar display indicating no firmware
> > has been loaded.
>
> I've only verified pbForth being uploaded using the commandline
> version of NQC.
>
> > Had NO problem loading original RCX firmware, Firm0309.lgo, with same
> > configuration!! Placement of IR tower was OK.
>
> This is good. Has anyone else out there tried RCXCC to upload the pbForth
> firmware????
>
> Cheers,
>
> Ralph Hempel - P.Eng
>
> --------------------------------------------------------
> Check out pbFORTH for LEGO Mindstorms at:
> <http://www.hempeldesigngroup.com/lego/pbFORTH>
> --------------------------------------------------------
> Reply to: rhempel at bmts dot com
> --------------------------------------------------------
--
George Lampke
glampke@verinet.com
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
