 | | Translating NQC 1.x to NQC 2.0
|
|
The next version of RCX Command Center (expect a beta at the beginning of the comming week) will contain a command to translate from NQC 1.x to NQC 2.0. It is not completely fool-proof but seems to work in almost all cases. Mark Overmars (26 years ago, 13-Aug-99, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: NQC 2.0 ready for beta test
|
|
yeah... mostly search-and-replace. Dave Baum wrote in message ... (...) (26 years ago, 11-Aug-99, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: IR-Tower and PowerBook-G3 ?
|
|
(...) Yes, AT is set to ethernet. (...) OK, I'll try that also. BTW, I now have nqc running on my *old* SE/30 (8MB) with a version of MPW I found on ETO-20. Everything seems to work fine. Downloads firmware as well as test.nqc Still mystified by the (...) (26 years ago, 11-Aug-99, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: IR-Tower and PowerBook-G3 ?
|
|
(...) I use the IR tower with a Wallstreet regularly (NQC was developed on my PowerBook), and I haven't had any problems. Did you make sure that AppleTalk is either set for Ethernet or turned off completely? You also may want to disable other (...) (26 years ago, 11-Aug-99, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: IR-Tower and PowerBook-G3 ?
|
|
(...) Yes. The PB-G3 is plugged into a wall-wart almost all the time. I thought of that also. Very strange. I'm resurecting an old SE/30 in the hopes that I can squeeze MPW into an 8MB machine. I think the serial ports on that machine ought to be (...) (26 years ago, 10-Aug-99, to lugnet.robotics.rcx.nqc)
|
