 | | NQC & Rotation Sensor
|
|
I have this program that monitors the location of a camera mount in a 360 degree turn. (0 and 16 are 0, 8 is 180 etc) However whenever I use SetSensor(SENSOR_2, SENSOR_ROTATION); it blanks the current sensor value when the program is restarted. This (...) (24 years ago, 25-Sep-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: NQC & Rotation Sensor
|
|
(...) The reset is a consequence of one of the bytecodes used to configure the sensor. I don't see a way to work around it. (...) This will have the same problem - in fact the generated code is probably identical (except for perhaps order) to just (...) (24 years ago, 26-Sep-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: NQC & Rotation Sensor
|
|
(...) Dave, Thanks for the reply, I had a bad feeling it would be this way. If that wasn't bad enough it keeps losing 2 points when stepped from 0 to 16 and back again... Most annoying. I'm going to move to a touch sensor bump mode... This way my (...) (24 years ago, 26-Sep-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: NQC & Rotation Sensor
|
|
(...) Do you have the sensor at a place where one rotation of the sensor = 360 degrees of whatever you're turning? I'd suggest putting it somewhere where it rotates a lot more times than the actual turntable. (You need a touch sensor for 0 this way, (...) (24 years ago, 26-Sep-00, to lugnet.robotics.rcx.nqc)
|
