Subject:
|
Re: datalog viewer in RcxCC
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Mon, 21 Feb 2000 12:31:06 GMT
|
Viewed:
|
2047 times
|
| |
|
|
Matthew Miller wrote in message ...
> Rebel Transcanner <hendryjr@oxford.net> wrote:
> > No idea. I'm using a shell program running under WindowsCE on my HP 320LX.
> > (VERY handy being able to write code while siting on the floor in my
room).
> That's pretty cool. I didn't know there was a Wince port.
>
> In any case, if you're doing > redirection and getting an error about the
> file you're redirecting to, the issue isn't with NQC but rather something • in
> your shell. Probably access permissions, but it could be screwed up in some
> other way.
Is there a DOS switch or something I should be looking for to enable file
writing?
Iain
--
tokama http://www.oxford.net/~hendryjr
ICQ UIN 5362826
AIM Linjerflyg
h e n d r y j r AT o x f o r d DOT n e t
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: datalog viewer in RcxCC
|
| (...) That's pretty cool. I didn't know there was a Wince port. In any case, if you're doing > redirection and getting an error about the file you're redirecting to, the issue isn't with NQC but rather something in your shell. Probably access (...) (25 years ago, 21-Feb-00, to lugnet.robotics.rcx.nqc)
|
12 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
