 | | Re: Watching Arrays
|
|
(...) The way to do this is to find out the variable number assigned by NQC to your array variable and then watch that variable number plus all the ones up through the size of your array. You can find out the variable number by viewing the code (...) (18 years ago, 17-Aug-06, to lugnet.robotics.rcx.nqc)
|
| |
| | Watching Arrays
|
|
I have a program (RCX2 target) that uses a couple of global arrays. I am using BricxCC 3.3 How can I view the contents of the array at run time? "Watch the Brick" shows me Var0 to Var 31 but these don't seem to relate/contain the values I initially (...) (18 years ago, 17-Aug-06, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: swan firmware motor problem
|
|
(...) I have tried it, but it did not make a difference. The motors still won't run. I must admit that I did not think of it before because I thought (maybe wrongly) that the old API would stay the same and that you would have to use the new (...) (18 years ago, 11-Aug-06, to lugnet.robotics.rcx.nqc)
|
| |
| | RE: swan firmware motor problem
|
|
I will post latest firmware on web site soon. -----Original Message----- From: news-gateway@lugnet.com [mailto:news-gateway...ugnet.com] On Behalf Of Gustavo Brinck Sent: Thursday, August 10, 2006 7:27 PM To: lugnet.robotics.rcx....lugnet.com (...) (18 years ago, 11-Aug-06, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: swan firmware motor problem
|
|
(...) I don't have the new firmware, but maybe you can try: #define NORMAL_SPEED 100 because, now the firmware have 100 step of motor pwr control. Best Regards Gustavo (18 years ago, 11-Aug-06, to lugnet.robotics.rcx.nqc)
|
