Subject:
|
Re: swan firmware motor problem
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Fri, 11 Aug 2006 00:27:27 GMT
|
Viewed:
|
10459 times
|
| |
|
|
In lugnet.robotics.rcx.nqc, John Hay wrote:
> #define NORMAL_SPEED 7
I don't have the new firmware, but maybe you can try:
#define NORMAL_SPEED 100
because, now the firmware have 100 step of motor pwr control.
Best Regards
Gustavo
|
|
Message has 2 Replies:
 | | RE: swan firmware motor problem
|
| I will post latest firmware on web site soon. -----Original Message----- From: news-gateway@lugnet.com [mailto:news-gateway...ugnet.com] On Behalf Of Gustavo Brinck Sent: Thursday, August 10, 2006 7:27 PM To: lugnet.robotics.rcx....lugnet.com (...) (18 years ago, 11-Aug-06, to lugnet.robotics.rcx.nqc)
| | | Re: swan firmware motor problem
|
| (...) I have tried it, but it did not make a difference. The motors still won't run. I must admit that I did not think of it before because I thought (maybe wrongly) that the old API would stay the same and that you would have to use the new (...) (18 years ago, 11-Aug-06, to lugnet.robotics.rcx.nqc)
|
Message is in Reply To:
| | swan firmware motor problem
|
| Hi, I trying out the Swan firmware (Fast0103.lgo) with nqc 3.1 r4 but for some reason the motors won't turn on. Has anybody seen something like that? If I run the program, it does all the other things, even switch on the little motor triangles on (...) (18 years ago, 9-Aug-06, to lugnet.robotics.rcx.nqc)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
