|
|
 | | Re: IR-based proximity measurement
|
| (...) Well, there were a couple of typos, but only one I found that was critical. If you are using a "max-picking LIDAR" method, you do *not* want to divide by the number of samples. The variable "eyeon" in your code should end up with the brightest (...) (18 years ago, 9-Jun-06, to lugnet.robotics.rcx.nqc)
| | | | | Re: IR-based proximity measurement
|
| (...) i have downloaded the SerialPing.nqc program hoping to get an easy to use proximity sensor. i have modified it to work with only one light sensor. but it shows always -90 on the display. ok, sometimes -89 too. can anybody tell me, what i did (...) (18 years ago, 9-Jun-06, to lugnet.robotics.rcx.nqc)
| | | | | Re: RCX remote jammer
|
| (...) I haven't actually used the program in a long time, and I'm getting compiler errors now - I think I've updated BricxCC/NQC since then, and I might have to adjust a few things. At any rate, it shouldn't be far from working, so play around with (...) (19 years ago, 17-Apr-06, to lugnet.robotics.rcx.nqc, FTX)
| | | | | RCX remote jammer
|
| this is going to be short, b/c I only have a minute. Check out (URL) (after mod) for an NQC program that will allow you to jam almost any IR remote control signal. Direct prgm link: (URL) Instructions: (URL) Enjoy, and please give me feedback (...) (19 years ago, 16-Apr-06, to lugnet.robotics.rcx.nqc, FTX)
| | | | | Re: BricxCC Feedback Requested
|
| (...) I've never docked the current toolbars to the side. I wouldn't miss it. (...) I do normally rearrange them (normally to a single row). I'd be annoyed for a few minutes then forget all about it if it was removed :) (...) Personally, I hate the (...) (19 years ago, 16-Apr-06, to lugnet.robotics.rcx.nqc)
|
|
