 | | Re: Battery voltage available within NQC?
|
|
(...) If you REALLY wanted to do this, you could use the bytecode to broadcast the battery information to the IR tower and have a service running on the PC which would recieve the battery message and then send an appropriate message back to the RCX. (...) (26 years ago, 12-Mar-99, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Battery voltage available within NQC?
|
|
(...) There's a bytecode (0x30) that instructs the RCX to send the battery voltage as a response over the IR. That's what NQC and Mindstorms use to read the battery voltage. I don't think this opcode has any effect within a program, or at best it (...) (26 years ago, 12-Mar-99, to lugnet.robotics.rcx.nqc)
|
| |
| | Battery voltage available within NQC?
|
|
Last night I went out and bought six C cell nicads and wired them up as a power supply for my robot. What I'm wondering is this: is there some way to programmatically obtain the battery voltage, so I could make a decision based on a voltage (...) (26 years ago, 11-Mar-99, to lugnet.robotics.rcx.nqc)
|
| |
| | RcxCC version 2.2 available
|
|
I am happy to announce the public release of version 2.2 of RCX Command Center. RCX Command Center is a Windows (95, 98, NT) program that assist you in programming the Lego MindStorms or CyberMaster Robots. It provides a higher level interface to (...) (26 years ago, 10-Mar-99, to lugnet.robotics.rcx.nqc, lugnet.robotics)
|
| |
| | Re: RcxCC for NQC 1.1?
|
|
I have not done extensive testing but it worked for me. Replaced nqcc.exe and nqc.h with the new versions 1.2. (...) (26 years ago, 9-Mar-99, to lugnet.robotics.rcx.nqc)
|
