|
|
 | | Re: Swan firmware crash!
|
| (...) I already post a simple code that causes the error: (URL) task main{ SetMotorPower128(MTR_A,100); SetOutput(MTR_A,OUT_REV); Wait(300); Off(MTR_A); } The command SetMotorPower128 is the cause. (if I remove it, all works). Today I get also the (...) (19 years ago, 20-Jul-05, to lugnet.robotics.rcx.nqc)
| | | | | RE: Swan firmware crash!
|
| Exception error 40 is intended to indicate that you've tried to write to an invalid source parameter value. "Source parameter" is the first byte of an internal interpreter variable (0 is variable, 2 is constant, etc). If you send me the NQC source I (...) (19 years ago, 20-Jul-05, to lugnet.robotics.rcx.nqc)
| | | | | Re: Swan firmware crash!
|
| (...) Here is Bricxcc help about those commands: SetMotorPower128(const int motor, const int &v) Function - Swan Set the power of a motor to the specified value (using a scale from 0 to 127). SetMotorPower128(MTR_A, 100); ___...___ (...) (19 years ago, 20-Jul-05, to lugnet.robotics.rcx.nqc)
| | | | | Re: Swan firmware crash!
|
| (...) That's where your completely wrong. I can see the error, calls to motor power should be set out like this motorPower128(1) = MyVariableName; in this example the constant "1" means set the power to output B to the value specified by (...) (19 years ago, 20-Jul-05, to lugnet.robotics.rcx.nqc)
| | | | | Re: Swan firmware crash!
|
| (...) * Maybe I wasn't too clear, but really there isn't much to say: it is the SetMotorPower128 command that causes the error. * Another question is: why costants MTR_A or MTR_B don't work at all? Here's the code(all the code): task main{ (...) (19 years ago, 20-Jul-05, to lugnet.robotics.rcx.nqc)
|
|
