To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.rcx.legosOpen lugnet.robotics.rcx.legos in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / RCX / legOS / 3358 (-5)
  Re: Programming in Assembly
 
A direct link to the page with the documents is (URL) Jürgen Stuber <stuber@loria.fr> (URL) rot 13 "fr" "se" (21 years ago, 17-Jul-03, to lugnet.robotics.rcx.legos)
 
  Re: Programming in Assembly
 
(...) You should look at Kekoa Proudfoots documentation of RCX internals ((URL) and his librcx library to understand the calling convention for the ROM. Then get yourself the H8300 tools (gcc et al) somewhere, this includes assembler and (...) (21 years ago, 16-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
 
  Re: Programming in Assembly
 
(...) mentioned previously) that describes the on chip I/O features of the H8 if you plan on doing any work with the sensors. (...) to (...) that (...) To turn on motor C forward you would do this: mov #0x02,r0h mov r0h,@0x80:8 The second (...) (21 years ago, 17-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
 
  Re: Programming in Assembly
 
Cool, thanks I was able to find the doc here: (URL) post about the motor seems helpful, so if I understand right the way to run motor A forward would be "mov 0x030003,r0h mov 0x80,r0h" and for the motor C the same except 0x06? How does the (...) (21 years ago, 17-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)
 
  Re: Programming in Assembly
 
Here's a more direct link for the H8 docs: (URL) down to the literature section and download the two PDFs. For assembly, I would recommend starting off with an installation of BrickOS and perusing the various source code files for the kernel. You'll (...) (21 years ago, 16-Jul-03, to lugnet.robotics.rcx, lugnet.robotics.rcx.legos)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR