Subject:
|
Re: BrickOS motor-output: Subject to change?
|
Newsgroups:
|
lugnet.robotics.rcx.legos
|
Date:
|
Tue, 15 Jul 2003 00:59:31 GMT
|
Viewed:
|
6479 times
|
| |
|
|
Do you use another firmware downloader besides firmdl3?
Recent changes to BrickOS changed the memory layout a bit
and this could be an issue. For example, I just discovered
that the nqc firmware downloader doesn't like firmware files
with non-contiguous blocks of code.
Mark
"Dietmar Cordes" wrote:
> Hi,
>
> I remember. I have tried brickOS 0.2.6.10 but I had problems with
> downloading the firmware. I was unable to get the new kernel into the
> RCX. I do not have this problem with 0.2.6.9.
>
> Thanks,
> Dietmar
>
>
> Mark Riley wrote:
>
> > Hi Dietmar,
> >
> > Have you tried brickOS 0.2.6.10? Code was added
> > to that version to address this issue.
> >
> > Mark
>
> [...]
> > > while doing some testing with data transfer wia the motorport of the
> > > RCX, I had (again) the problem that the output at full speed (255) is
> > > not a constant DC-output.
> [...]
>
|
|
Message is in Reply To:
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
