 | | BrickOS motor-output: Subject to change? —Dietmar Cordes
|
| | | Hello, while doing some testing with data transfer wia the motorport of the RCX, I had (again) the problem that the output at full speed (255) is not a constant DC-output. Does anyone have a good solution for this already and will it be part of the (...) (21 years ago, 8-Jul-03, to lugnet.robotics.rcx.legos)
|
| | | |
| | | | | Re: BrickOS motor-output: Subject to change? —Mark Riley
|
| | | | Hi Dietmar, Have you tried brickOS 0.2.6.10? Code was added to that version to address this issue. Mark "Dietmar Cordes" <cordes@lepomux.org> wrote in message news:3F0A7BA7.207050...mux.org... (...) (21 years ago, 8-Jul-03, to lugnet.robotics.rcx.legos)
|
| | | | |
| | | | | | Re: BrickOS motor-output: Subject to change? —Dietmar Cordes
|
| | | | Hi, I remember. I have tried brickOS 0.2.6.10 but I had problems with downloading the firmware. I was unable to get the new kernel into the RCX. I do not have this problem with 0.2.6.9. Thanks, Dietmar (...) [...] (...) [...] (21 years ago, 14-Jul-03, to lugnet.robotics.rcx.legos)
|
| | | | |
| | | | | | Re: BrickOS motor-output: Subject to change? —Mark Riley
|
| | | | Do you use another firmware downloader besides firmdl3? Recent changes to BrickOS changed the memory layout a bit and this could be an issue. For example, I just discovered that the nqc firmware downloader doesn't like firmware files with (...) (21 years ago, 15-Jul-03, to lugnet.robotics.rcx.legos)
|
| | | | |
